First you have to decide in which operating mode you wish to operate the IntegraMouse Plus.

• Connected by cable, i.e. directly connected to the computer via USB cable
• Wireless transmission with battery powered operation of the IntegraMouse Plus
• Wireless transmission with operation of the IntegraMouse Plus via the power pack included
  
  

IntegraMouse Plus in wireless mode with battery operation

In order to use wireless mode, IM+Connect is required.

1. Insert the IM+Connect into one of the computer's USB ports.
2. Switch the IntegraMouse Plus on by pressing the ON/OFF button. The calibration process starts and will be shown by the running LEDs.
3. After successful connection, the green LED on the IM+Connect and the IntegraMouse Plus is active for use.

Ensure that the battery of the IntegraMouse Plus is charged enough when in wireless mode. More information on the charging display can be found in Chapter 9.3 "Recharging the battery".

The IntegraMouse Plus and IM+Connect must be coupled for use. This linking-up is carried out as standard before delivery and need not be carried out by the user.

When replacing the IM+Connect or in case of problems with the wireless connection, the linking procedure can be carried out manually as follows:

Linking up IntegraMouse Plus and IM+Connect

1. Disconnect the IntegraMouse Plus from the power pack or the USB cable.
2. Switch off the IntegraMouse Plus (see Chapter 8.4).
3. Insert the IM+Connect into one of the computer's USB ports.
4. Press the "Connect" button on the top of the IM+Connect with the help of a sharp object (e.g. ballpoint pen, paper clip,...). The linking process starts. The green LED on the IM+Connect flashes.
5. Switch on the IntegraMouse Plus by pressing the ON/OFF button and keep this pressed down for about 3 seconds (Warning! The IntegraMouse must be switched off and must not be connected to the power pack). After the running lights have come on once, the blue LEDs on the IntegraMouse Plus begin to flash alternately.
6. After successful connection, the green LED on the IM+Connect and the IntegraMouse Plus is active for use.

IntegraMouse Plus in wireless mode with supply via the power pack

1. Insert the IM+Connect into one of the computer's USB ports.
2. Connect the IntegraMouse Plus to a plug using the power pack.
3. The IntegraMouse Plus switches on automatically and the calibration process is shown through the running LEDs.
4. After successful connection, the green LED on the IM+Connect and the IntegraMouse Plus is active for use.